Atag WO3011AA Instrukcja Użytkownika Pobierz pdf (Strona 7)

7

Burner cover/inner burner

ring/outer burner ring

Together with the inner burner ring the

outer burner ring forms a space where the

final mixture of gas and air takes place in

order to make the gas burn correctly.

Please note: It is consequently very

important that the inner burner ring/outer

burner ring is placed correctly, together

with the cover.

If the burner cover/rings are wrongly

placed the burner will operate incorrectly,

and the burner may be damaged within a

short space of time. It is also important,

that the inner air ring is placed correctly.

Ignition electrode (A)

The burner has been provided with an

ignition electrode. As long as the

operating knob is depressed, the

automatic ignition will ensure that a

spark is emitted between the ignition

electrode and the burner cover.

Thermo Sensor (B)

The gas unit features fully-secured gas

taps (thermo-fuse)

In case the flame goes out, the thermo

sensor automatically prevents gas

admission after a shorter time (Max. 90

seconds).

Note: Gas admission is always allowed

while the operation button is pressed -

See start-up procedure

Cover

Burner ring

Ignition electrode (A)

Thermo Sensor (B)

Burner Main nozzle

18

Model: WO3011AA20BE/A1

Type of gas

Adjusted for: Natural: G-20 - 20mbar

G-25 - 25mbar

Category and pressures

BE: II

2E+3+

20/25 - 28/37 mbar

Max. nominal load Q, H

S

:

Wok burner = 5,0 kW x 1

Total= 5,0 kW

Convertible to bottledgas: G30-28/37 mbar

FSD

The unit features fully-secured gas taps

(thermo-fuse).

H

S

= Gross calorific value

Q = Nominal load

Voltage= 220-240 V AC

Ignition transformer= 50 HZ - 0,6 VA

CE 048 AT- 0030

Radio-noise reduction

This unit observes the current EEC-directive

on radio noise reduction.

This gas appliance is -approved and

marked in accordance with the gas appliance

Directive (90/396/CEE), the low voltage

directive (73/23/CEE) and the EMC directive

(89/336/CEE incl. the agreed directive

changes.

Technical data

The Dropinett must be connected via

an external switch with a contact

gap of min. 3 mm (the main switch

may be used)

Cable type: 0,75 mm² HO5VV-F

N L1

230 V

1N + PE

1 2 3 4 5 6 7 8 9 10 11 12

Komentarze do niniejszej Instrukcji

Brak uwag